700 Series Regulator
|
|
Primary Use: | These
regulators are a single stage design used for the 2AL, 8AL, 6D, 7EOC, 7HP and 5E cylinders. The 700 series regulators are preset to deliver gas at a flow rate specified by the user. The 700 series regulator may be divided into three groups. |
||||
| Model 713: | The
713 has a maximum inlet pressure of 500 psig/35 bar and an inlet fitting to match the CGA 600 in the 7EOC and 7HP cylinders. |
|||||
| Model 715: | The
715 has a maximum inlet pressure of 1000 psig/70 bar and fits the 2AL, 8AL and 6D cylinders. |
|||||
| Model 718: | The
718 has a maximum inlet pressure of 3000 psig/207 bar and can be used as an economical single stage regulator for use on 5E and refillable cylinders with CGA fittings. |
|||||
| Model No. | Maximum
Inlet Pressure |
Maximum
Outlet Pressure |
Inlet | Outlet | Gauge* | |
| 713 | 500 psig/35 bar | 20
psig/ 1.4 bar |
CGA 600 | 3/16"
Barb/ 4.8 mm |
0-500
psig/ 35 bar |
|
| 715 | 1000 psig/70 bar | 60
psig/ 4.1 bar |
5/8 x 18 | 3/16"
Barb/ 4.8 mm |
0-1000
psig/ 70 bar |
|
| 718 | 3000 psig/207 bar | 60
psig/ 4.1 bar |
1/4" NPT | 3/16"
Barb/ 4.8 mm |
0-3000
psig/ 200 bar |
|
| Standard
flow rates are 0.5LPM, 1.0LPM, and 1.5LPM; however, these
regulators may be ordered with a preset flow as low as 0.2LPM, or as high a 6.0LPM. (4LPM is maximum for model 713). |
||||||
| Construction | Body: |
Brass |
||||
| Seat: |
Teflon® |
|||||
| Piston: | Brass | |||||
| Washer: | Buna N (713 only) | |||||
| O-Rings: |
Viton® |
|||||
| Bonnet: |
Nickel plated brass |
|||||
| Weight | 713: | 0.6 lb/0.28 kg | ||||
| 715: | 0.5 lb/0.24 kg | |||||
| 718: |
0.7 lb/.032 kg |
|||||
| Warranty |
All regulators are warranted for two years. |
|||||
| ®
registered trademarks of The DuPont Company. * Gauge indicates cylinder pressure in both psig and bar. |
||||||
